DCC Ready - What Does it Mean?

In the "turn of the millennium" time frame, it didn't mean much more than the art department at the manufacturer could spell "DCC". As time has gone by, things have improved.

For a look at what things were like in the 2005 - 2007 time frame, there is Bruce's oft requested clinic: "DCC Ready, the Good, the Bad and the UGLY" - click on this link to see the PowerPoint presentation of the 2006 version.

There can be shorts between the rail power and motor power or lights as part of the internal wiring of the loco. As long as the plug is inserted, this short cannot be identified. Bruce recommends using a BUZZER or ohm meter, probe the gray and black sockets and then the red and orange sockets. There should be high resistance - no buzz. Also probe between the track (black) and light circuits (green, yellow white and blue). Again, no continuity. Finally, probe red rail to lighting.

HO and larger scales

Today, there are many versions of "DCC Ready" locos in HO scale. Most mean what they say. The come in various types:

NEM-652 (NMRA Medium) 8-pin socket
NEM652-1

This socket, as shown to the right, is one of the most frequent versions. It has connections for the track power, motor and two lights, per the NMRA standard. A third light function (pin 3 - the green wire) as shown below has been implemented by some manufacturers of locos and decoders. There may be some issues with this, as it is NOT an NMRA standard. For example, the Blueline series from BLI will not function correctly with a decoder that implements the green wire function - clipping the green wire off the plug, fixes the issue.

NEM652 NMRA 8-pin Wiring Diagram


This connector is NOT POLARIZED. What that means is that you can plug it into the socket in either direction. The good news is that, except for the green pin discussed above, there will be no damage to either the decoder or the loco if you reverse it. If you plug it in backwards, the lights won't work and the loco will run backwards. Just rotate it a half-turn and plug it in. This "no damage" is not true if you plug it in offset.

JST 9-pin socket

The (usually white) in-line 9-pin socket is used in many locos, for example, the newer Athearn RTR and Genesis locos. The plug (decoder side) of this connection is shown to the left, with the NMRA standard color coding. There is frequently a jumper plug in the loco that makes the connections between the rails and the motor and lights. Once you remove the jumper plug and determine there is no short, as explained above, it is a simple matter of plugging in the JST style decoder of your choice.

This connector is polarized. It cannot be plugged backward without a lot of force and damage. See the little tabs on this photo. They are offset so that you cannot plug it in backwards. Of course, if you file them off, then you can reverse the plug in the socket!

For this reason Bruce recommends that you use the 9-pin JST style connector whenever possible, for example on the Athearn RTR locos.

N Scale

There are two types of connectors widely used in N scale today::

NEM-652 (NMRA Medium) 8-pin socket

This socket, as shown above, is used in some N scale locos. Usually it is too large for easy connection. Frequent users are the Walthers' tank switchers and some Con-Cor steamers. Remove the jumper, check for shorts as discussed above and plug the decoder in.

NEM-651 (NMRA Small) 6-pin socket

Frequently used in European locos and becoming more widely used in American locos is the NEM-651 socket, as shown on the right. Remove the jumper, check for shorts as discussed above and plug the decoder in.

This socket is NOT POLARIZED. Hopefully the mating connector is color coded. If you are using a decoder with the 6-pins on it, consult the manufacturer's literature to find out which direction has the right and left wires.

Copyright © Bruce F. Petrarca 2007 - 2017; All Rights Reserved