Proto 2000 SW9

WARNING - this is not an install for the faint of heart!

The photo below shows the pre-installation before final assembly. After assembly, there isn't a lot to photograph!

Life-Like-Proto2000-SW9-826001-1


Install LEDs and resistors for front and rear lights. Install speaker in cab as shown and seal the remaining openings in the cab with styrene. Cut down the weight to make room for the decoder and capacitor. Isolate the motor. Then install the Micro Tsunami decoder and capacitor.

If these instructions are not enough for you to know EXACTLY what you need to do to install this decoder, YOU SHOULD HAVE A PROFESSIONAL DO YOUR INSTALL! There is barely enough room in this loco for a sound install and any mis-step will result in less than desirable sound and / or performance.
For example, CONTACT BRUCE!

Copyright © Bruce F. Petrarca 2007 - 2017; All Rights Reserved